Digitrax DT400 Display defekt!?

  • Hallo,


    bei meinem Handregeler DT400 von Digitrax ist das Display anscheinened kaputt.
    Nach einem Kurzschluss am Gleis, bemerkte ich das der Regler nur noch Unfug angezeigt hat. Nach dem Aus- und wieder Einstecken des Loconet-Kabels blieb das Display dunkel. Die Züge ließen sich aber noch steuern.


    Hatte schon mal jemand dieses Problem?
    Hat jemand Erfahrung mit dem Reparaturservice von Digitrax?

  • So Zeug hatte ich auch schon erlebt, mein Tipp, diese Steuerung vertragen ab und an mal einen Resett und plötzlich fährt alles wieder wie früher.



    Tom

  • So nachdem das Display gestern wieder ausgesetzt hat, möchte ich mal kurz berichten, falls mal jemand das gleiche Problem haben sollte:


    Habe heute an den Digitrax Support geschrieben, was leider nur mit Erstellung eines Account funktioniert. Nicht mal eine Stunde später kam folgende Antwort:
    "
    It may be as simple as a loose CPU. To check that hold the throttle
    with the keys/display facing away from you and then slap it two or
    so times in your cupped hand to "jar" the CPU into it's socket.
    That works well often so try it. If that does not work you will
    have to send it in for repair.
    For Repairs please go to the Digitrax website, www.digitrax.com and download and fill out the repair form you will find on the
    home page under "Support/No Worries Warranty". For Warranty repairs
    Receipts are required. It is very important a copy of the REPAIR
    FORM be filled out and ENCLOSED INSIDE the package. Please send
    attention Repair Dept. Digitrax, 2443 Transmitter Rd., Panama City,
    FL 32404.Please note that all tickets are Administratively Closed
    after a response is made. If further communication is required,
    please reopen the ticket instead of creating a new one.


    Your The Digitrax Help Desk Team,
    Digitrax
    Tech Support
    2443 Transmitter Rd
    Panama City, FL 32404
    850-872-989
    "
    Kurz zusammengefasst: Sie vermuteten, dass die CPU etwas aus ihrem Sockel gerutscht ist und ich soll den Regler mit der Seite mit den Knöpfen voran in meine Hand schlagen, damit die Cpu wieder an ihren Platz rutscht.


    Habe ich dann so gemacht, erst nur leicht ohne Erfolg und dann nochmal ziemlich fest und oh Wunder, das Display lebt wieder :)

Jetzt mitmachen!

Du hast noch kein Benutzerkonto auf unserer Seite? Registriere dich kostenlos und nimm an unserer Community teil!